Timescapes - Digital Timelapse Discussion
http://forum.timescapes.org/phpBB3/

MX2 to Camera cable
http://forum.timescapes.org/phpBB3/viewtopic.php?f=28&t=11880
Page 1 of 1

Author:  Astroman [ Tue May 13, 2014 7:10 pm ]
Post subject:  MX2 to Camera cable

Hi all,

is the cable that goes between the MX2 and the Camera (in my case a Canon 1100D (E3 plug)) use straight through wiring between the 2.5mm and 3.5mm jacks? Does anyone have a schematic of the cable.

Thanks.

Author:  RogerBotting [ Thu May 15, 2014 10:13 am ]
Post subject:  Re: MX2 to Camera cable

If you have the cable, use your voltmeter to do a schematic.
No voltmeter? light bulb and a AA battery will do.

Author:  Astroman [ Thu May 15, 2014 12:35 pm ]
Post subject:  Re: MX2 to Camera cable

Hi Roger,

I am asking if the wiring is straight through so I can make my own, that is why I asked for the schematic. Apologies, I should have worded it better. If it's just a standard plug on each end with tip to tip etc... wiring I will make my own up.

Author:  Astroman [ Thu May 15, 2014 11:51 pm ]
Post subject:  Re: MX2 to Camera cable

Thanks to Dynamic Perception on Facebook I was able to get the answer I was looking for, thanks.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/