Timescapes - Digital Timelapse Discussion
http://forum.timescapes.org/phpBB3/

MX2 Dolly
http://forum.timescapes.org/phpBB3/viewtopic.php?f=31&t=11984
Page 1 of 1

Author:  lavds [ Tue Jun 17, 2014 1:37 am ]
Post subject:  MX2 Dolly

After resetting settings, the Dayton gearmotor does not work (https://www.acklandsgrainger.com/AGIPortalWeb/WebSource/ProductDisplay/globalProductDetailDisplay.do?item_code=DMD2L007 )

Need change minimal impulse? Which value? I have tried different, does not work.

Author:  RogerBotting [ Tue Jun 17, 2014 8:39 am ]
Post subject:  Re: MX2 Dolly

Do a review of what you are doing. It might sound trivial but its what everyone else would do if they had to fix it.
Power?
Connections?
Settings? Is it set to do anything?
Change wires?
Still doesn't work?
test motor, apply correct voltage to motor to see if that works. Isolate components.
Motor works > then attach 12 volt light bulb to motor output on MX-2 (ext0 and ext1), does it flash on occasion?
try a different power source
check connecting wires
check belt tension, too tight? motor stalls, too loose and the motor turns but the belt slips.

Once you isolate the problem then you can start the actual repair. And sometimes the repair starts with RTFM.

All learned while working at a camera repair shop years ago.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/